Please read the manual carefully before operating the vehicle. And master vehicle performance; Carefully check whether the vehicle is normal before each use, it is strictly prohibited to use the vehicle with faults; Without training, it is strictly prohibited to repair, overload is strictly prohibited. The center of gravity of goods must be within two forks. Do not move loose goods. Move the vehicle slowly when the fork is entering and leaving the pallet. It is forbidden to press the up or down button when the car is walking, and it is forbidden to switch the up and down button quickly and frequently, which will cause damage to the car and goods. When the van is not in use, the fork should be lowered to a lower position. Do not place any part of the body under the weight and fork.
It is more and more common for people to use electric stacker in the field of logistics such as factories, mines, workshops and ports, and its appearance provides help for people’s cargo handling work, and saves manpower and material resources. What is the solution to the fault of dalian stacker and fork maintenance? This may be the battery voltage is too low, and the motor brake is not adjusted well, the accumulation of debris between the commutator pieces of the motor caused by short circuit between the pieces will also cause this phenomenon. You can replace the battery, re-adjust the motor brake, and add new and clean lubricating oil.
The door frame is tilted or unbalanced, which may be the wear of the cylinder wall and the sealing ring. The accumulation of debris in the cylinder is too much or the sealing pressure is relatively tight; The piston rod is bent or the piston is stuck on the cylinder wall. Can replace the new seal ring, clear cylinder and adjust the seal, replace the piston rod or cylinder. The circuit of the electric stacker runs abnormally. It may be that the switch inside the electrical box is broken or the position is not adjusted properly, and the fuse inside is broken, and the battery voltage is too low, and the contactor coil is short-circuited. You can replace the switch and adjust the position, replace the fuse, the power is sufficient, replace the contactor.
With the development of society, people pay more and more attention to the concept of environmental protection, so is the logistics handling industry, so environmental protection logistics handling equipment gradually into the sight of people, the use of electric stacker is a good example. Check the working condition of the brake and pump station before running the all-electric stacker, and ensure that the battery is fully charged. Hold the control handle with both hands and drive the stacker slowly towards the working cargo. If you want to stop the stacker, you can use the hand brake or the foot brake to stop the stacker.
Post time: Dec-20-2021